Appendix
Safety
• Read and follow these cautions and warnings before using Kodak products.
• Always follow basic safety procedures.
• Follow all warnings and instructions marked on the Kodak ESP·3 All-in-One printer.
Parts
Caution Do not disassemble this product; there are no user-serviceable part(s)
inside. Refer servicing to Kodak qualified service personnel.
Warning Keep out of reach of children. Ink may be harmful if swallowed.
Power
Caution If the power cord or plug is frayed or damaged, the equipment gets wet, or
the equipment does not operate normally when the operating instructions are
followed, unplug your printer from the power outlet and refer servicing to qualified
service personnel.
Caution The AC adapter power supply is equipped with a three-wire grounding type
plug. If you cannot insert the plug into the power outlet, contact an electrician to
check or replace the power outlet.
Caution Do not plug the AC adapter into a household extension cord.
Caution For added protection from damage during a lightning storm, or any time
when your printer and its associated AC adapter will be left unused for long periods of
time, unplug the AC adapter from the power outlet.
Warning Pushing objects through the equipment openings can result in an electric
shock or risk of fire.
Warning The use of an accessory attachment that is not recommended by Kodak,
such as an AC adapter, could cause fire, electric shock, or injury.
Location
Caution To prevent your printer from overheating do not block or cover the slots and
openings in the equipment, place it near a heat register, or install it in a cabinet
without proper ventilation.
Caution Do not use your printer near water, or spill liquid on it.
Warning Do not place your printer on an unstable cart, stand, bracket, or table.
Injury to persons and damage to the equipment may occur.
Environment
Caution Excessive dust levels may damage internal parts.
User Guide 61
To Next Page
Loading...
