Chapter 8
Printing Stops
Printing stops during mid-print. Paper stops feeding, and status light may blink.
Important For best results, use Kodak ink cartridges and paper for your printer.
To check the paper
1 Remove any loose paper from the printer. Check the paper access door in the rear of the
printer.
2 Inspect the paper supplies and reload with new paper, if necessary.
3 Carefully "fan" the paper to keep the sheets from sticking together.
4 Reload the paper tray. Do not overload.
5 Press Copy to continue or Cancel to stop
White Edges on Borderless Prints
Probable Cause 1
White edges can appear when there are slight misalignments between the printer and paper. Some
software applications are able to “hide” these small misalignments so that the prints look
borderless like they are supposed to.
Corrective Action
• Realign the paper in the tray.
• Use the application's
Fit to Page/Fill Page option, or resize the picture so it is slightly larger
than the paper size.
Probable Cause 2
If the image's proportions or dimensions are not compatible with the selected paper size, the print
usually will not be borderless. For example, if a square image is printed onto 4 x 6 inch paper, it will
often print as a 4 x 4 inch image, with white edges on each side of the print.
Corrective Action 2
Crop the image so it is compatible with the selected paper size.
Copy Troubleshooting
Use this section to resolve the following copy problems.
Copy Cut Off
Probable Cause
The original is larger than the paper loaded.
Corrective Action
When the original is larger than the paper loaded, use the Fit to Page feature to reduce copy size
to fit the size of the paper loaded.
54 Kodak ESP·3 All-in-One
To Next Page
Loading...
