A-61560 April 2008 13
Turning on the scanner and
finalizing Kodak Driver
Software installation
When the USB cable and power connections have been made, and the
Kodak Software Drivers have been properly installed, the installation
will be complete when the scanner is turned on.
• Use the power switch on the back of the scanner to turn the scanner
on (I).
When you turn on the scanner, the scanner goes through an
initialization process. During the initialization process, the operating
system will auto detect your scanner and “Found New Hardware”
messages may be displayed.
When it is finished and ready to scan, the LED indicator will stop
flashing and stay green.
Installing application
software - Windows
operating systems only
The Kodak Scan Validation Tool is a test application that was
automatically installed as part of the Kodak Scanner installation CD.
Refer the section entitled, “Verifying your scanner installation” in
Chapter 3 for instructions and use.
Other scanning applications are also provided on the CDs packed with
your scanner (e.g., Kodak Capture Software Lite, Nuance ScanSoft
PaperPort Software, Nuance ScanSoft OmniPage Pro Software). You
may also use other scanning applications not provided with the
scanner. See the User Guides provided with these applications for
instructions on how to install and use the software.
To Next Page
Loading...
