24 A-61560 April 2008
Verifying your
scanner installation
The following steps help you to verify that your scanner installation was
successful. If this procedure is successful, you will be ready to use your
scanner. If it is not successful, go back and review the installation
procedures outlined in the section entitled, “Installing the scanner” in
Chapter 2.
Before you begin, be sure the scanner is on and ready to scan.
(Windows operating
systems only)
1. Select Start>Programs>Kodak>Document Imaging>Scan
Validation Tool.
The Scan Validation Tool dialog box will be displayed.
2. Select TWAIN for the Driver Types and Kodak Scanner i1210/
i1220 or i1310/i1320 as the Driver.
The Scan Validation Tool dialog box will be displayed.
3. Click the Setup icon.
To Next Page
Loading...
