A-61560 April 2008 79
Device - General tab The General tab allows you to set scanner-specific transport control
options.
Paper Source
• Automatic: looks for paper in the document feeder first. If there are
no documents in the input tray, the scanner will look for a document
on the flatbed.
• Document Feeder: when you are scanning documents from the
input tray.
• Flatbed: scanner will scan from the flatbed.
NOTE: Automatic and Flatbed options are only available if you had
the flatbed accessory attached when the scanning application
connected to the scanner
Power Saver — allows you to set the amount of time the scanner has
to be inactive before going into power saver mode. You can turn this
option off or set a time from 5 to 240 minutes.
Document Feeder
• Timeout: allows you to select the amount of time the scanner will
wait once the last document enters the feeder before the timeout
occurs. You can set a time from 1 to 30Action when timeout occurs:
• Action when timeout occurs: allows you to specify the action that
will be taken when the document feeder timeout has been reached.
- Stop Scanning: scanning will stop and control will return to the
scanning application (i.e. ends the job).
Diagnostics — provides access to the Diagnostics tab.
To Next Page
Loading...
