26 A-61560 April 2008
7. Click the Start Scanning icon on the Scan Validation Tool dialog
box. The documents will be scanned and displayed in the Scan
Validation Tool window. Be sure that one of the window display
icons is selected, otherwise the scanned images will not be visible.
NOTE: If the scanner is in lamp saver mode, a message will be
displayed that the lamps need sufficient time to warm up.
After the images have been displayed, your scanner installation
verification is completed.
8. Click the Close box to exit the Scan Validation Tool. The images
you scanned can be found in the TWAIN folder on the C drive. Files
will be named using the following naming convention:
image0000001A.jpg is a front image; image0000001B.jpg is a
back image.
9. Double-click on this file to open and view the captured image.
NOTE: Because factory default settings were used, the image
quality may not be optimized to meet your needs. To learn
more about image processing features, see Chapter 4,
Image Processing, or refer to your scanning application
documentation.
10.When testing has been completed, delete the test images.
Linux operating systems 1. Open a terminal.
2. Run ScanTWAIN.
3. Select Scan>Select Scanner from the menu bar. The Select a
Scanner dialog box will be displayed.
4. Select the desired scanner and click OK.
5. When the scanner is ready (steady green LED), place some test
documents into the input tray of the scanner and click the Scan
button.
6. After the images have been displayed, your scanner installation
verification is completed.
Application
software
You may also use other scanning applications. See the User’s Guide
provided with these applications for instructions on how to use the
software.
Window
display icons
To Next Page
Loading...
