20 A-61560 April 2008
To install the output tray extender:
- Turn the output tray over and slide the output tray extender
along the rail of the output tray.
- Turn the output tray right-side up and slide it under the scanner
until it locks into place.
• The output tray extender is best used when the scanner is in the 25
degree position (see below). This setup is ideal for scanning large
batches of mixed document sets.
• In addition, the output tray can be extended to accommodate
documents up to 14 inches in length, and the end stop can be
opened at various angles.
Rail
End stop
Open to extend output tray
To Next Page
Loading...
