4-4 A-61796 September 2014
Network Destination Credentials — when selected, define the
Username, Password and Domain required to access network
resources.
NOTE: This is only used for network folders when Force User Login
(on the Active Directory Server screen) is not enabled.
1. Enter the network user name assigned to the Scan Station. For
more information see the section entitled, “Network configuration
details” in Chapter 2.
NOTE: If you want the Scan Station to have access to network
printers or network shared folders, the credentials provided
must have sufficient privileges to access these resources.
2. Enter the password for the network user name in the Password
field.
NOTE: This password is only used by the Scan Station and will
never be displayed in readable form. The password is
stored in encrypted format.
3. Enter the Microsoft network domain name which the Scan Station
will be connected to in the Domain field. In a workgroup
environment, this field can be left blank.
Automatic Configuration Schedule — the Scan Station can be
configured to look for an updated configuration on specific days and
times and firmware updates. Select this option to allow your Scan
Station to automatically look for an updated configuration.
1. Enter a network folder where the Scan Station will find updated
configuration settings.
2. Select which day(s) of the week this operation will be performed.
3. Select the time of day you want your Scan Station to check for
updates.
NOTE: When updating a configuration using this method, the fields
on the Add Scanner and Modify Scanner dialog boxes will
not be updated: Scanner Name, IP Address and Remote
Access Password.
To Next Page
Loading...
