1-4 A-61854 April 2016
8 ID-1 card positioning — for scanning one small card (i.e., US
driver’s license or other credit card sized ID cards) in portrait
orientation. There is also an ID-2 card placement position for
scanning one large card (e.g., German ID card issued prior to
November 2010) in landscape orientation (this position is not shown
in the ‘Front view’ illustration).
NOTE: ID cards with embossed characters should be positioned with
embossing side facing up.
9 Scanner cover release lever — opens the scanner to allow
access to the paper path for cleaning or clearing a document jam.
10 Operator Control Panel and buttons — the Operator Control
Panel displays messages, network connection information and
predefined Smart Touch functions 1-9. When the “i” button is
pressed, network connection information will be displayed. See the
section entitled, “Using the Network Info/Setup icon (i) on the
scanner” in Chapter 2 for more information.
Following are some icons that may be displayed on the Operator
Control Panel
.
Indicates that documents are in the input tray.
Indicates that no documents are in the input tray.
Indicates a Wireless connection. The number of bars represent
the strength of the connection; four bars indicate full signal
strength.
NOTE: If the Wireless icon is not displayed, then the Wireless
Network has not been detected, please wait.
• If an explanation mark is displayed over the Wireless icon, wait
at least 1-2 minutes.
• If the explanation mark is red, the Wireless Network currently
cannot be associated for any number of reasons (e.g., incorrect
security key, unsupported encryption type, not ready, etc.).
• If the explanation mark is yellow, an IP address has not been
assigned due to a slow or improperly configured router.
Indicates a Wired Ethernet connection. This icon is displayed if the
Wired Ethernet connection is enabled.
Indicates a USB connection. This icon is displayed if the USB
connection is enabled.
Indicates the scanner is acting as a Wireless ad hoc connection
for using Wireless Directly between the host device and scanner.
To Next Page
Loading...
