Kodak ScanMate i1150WN - Wired Network with Optional Wireless Directly (Ad Hoc) Connection

2-14 A-61854 April 2016
Wired Network with
optional Wireless Directly
(ad hoc) connection
Configure the Wired Network and optional Wireless Directly (ad hoc)
connections by entering the appropriate information in the fields on the
Network tab.
The default network settings are:
Wired = ON; DHCP = enable
Wireless = ON; DHCP = enable; Mode = Wireless Directly;
SSID = ScannerModel-Scanner Serial # (e.g., i1150WN-12345678)
When configuring Wired Network, the Wireless Directly (ad hoc)
connection mode is always available unless it is unchecked on the
Network tab or the Wireless switch on the back of the scanner is in the
OFF position. Doing either of these will disable both Wireless
configurations to the scanner.
Wired Network options
• Obtain an IP address automatically — if you select this option, the
scanner will use DHCP to obtain an IP address to connect to the
network.
• Use the following IP address
- IP address: enter an IP address provided by your network
administrator.
- Subnet mask: enter the subnet mask provided by your network
administrator.
- Default gateway: enter the IP address of the gateway on the
network provided by your network administrator.