2-4 A-61854 April 2016
Overview The i1150WN and i1190WN Scanners provide the i1150WN/i1190WN
Scanner Setup website for updating firmware, and setting the scanner’s
connection mode. The scanner’s embedded website also allows you to
view status, firmware versions and configuration information.
From the scanner’s embedded website you can configure the scanner’s
connection mode in one of the following ways:
• Wired Network with optional Wireless Directly (ad hoc). See the
section entitled, “Wired Network with optional Wireless Directly (ad
hoc) connection” later in this chapter.
• Wireless Network. See the section entitled, “Wireless Network
connection” later in this chapter.
• USB with optional Wireless Directly (ad hoc). If you want to
communicate with your scanner using a USB connection, see the
section entitled, “USB with an optional Wireless Directly (ad hoc)
connection” later in this chapter.
The first time you access the website, it may be easiest to use the pre-
configured Wireless Directly (ad hoc) connection that is built into the
scanner to connect to the i1150WN/i1190WN Scanner Setup website.
This will enable you to reconfigure the wireless scanner to join your
companies wireless infrastructure network. It is recommended that you
set an administrator password to the website, via the Support tab. For
procedures on setting a password see the section entitled, “Setting or
changing a password” later in this chapter.
An EasySetup option is provided which allows you to create an
encrypted, printable PDF file that encodes your configuration
information.
NOTE: In addition to connecting to the scanner and using the scanner’s
embedded web pages to create a configuration, the same
pages are served from Kodak Alaris by entering
www.kodakalaris.com/go/EasySetup on the browser of your
choice.
To Next Page
Loading...
