A-61854 April 2016 2-9
Password protection When you access the website, an optional password protection dialog
box will be displayed if a password has been set. By default there is no
password.
This capability is provided to limit access to networking options you do
not want viewed or changed without authorization. The website’s
password can be managed directly from the scanner’s embedded web
pages (see the next section entitled, “Setting or changing a password”)
or by using the EasySetup option (see the section entitled, “Using the
special EasySetup Configuration page” later in this chapter).
If a password is set or is entered incorrectly, the Home page will still be
displayed; however, you will only have access to the Support, Status
and About tabs and the Update Scanner Firmware and Change
Admin Password buttons will not be displayed.
If no password is set or when the correct password is entered, all tabs
(Network, Device, Support, Status and About) and the Update Scanner
Firmware and Change Admin Password buttons will be available on
the Support tab. It is recommended that you set a password as part of
any configuration to protect your network settings from being changed.
NOTES:
• If you have set a password, the user will have to know what the
password is to have access to the Network and Device tabs.
• Login is session-based and is in effect as long as the browser is
open.
• To reset the password you can restart the scanner while holding the
Reset button on the back of the scanner.
• If you know the password and do not want to password-protect the
scanner, click the Change Admin Password button on the Support
tab to access the Change Admin Password dialog box. Enter the old
password and leave the Admin Password and Confirm Password
fields blank, then click Apply Password Change.
To Next Page
Loading...
