A-61854 April 2016 2-31
Using the Network
Info/Setup icon (i) on
the scanner
The Network Info/Setup (i) icon has two functions:
• When pressed once, the network settings are displayed, including,
but not limited to:
- Scanner name
- SSID
- Wireless Addr: 111.222.3.4. or none
- Firmware version
- Wireless Subnet Mask
- Wireless MAC Addr: 01.02:03:04:05:06
- Wired MAC Addr: 01.02:03:04:05:06
NOTE: The Up and Down arrows on the scanner Operator Control
Panel allow you to navigate through the Information pages.
• EasySetup mode: When the i button is pressed and held for about 4
seconds, the scanner will enter EasySetup mode. When in
EasySetup mode, do the following:
1. Insert the EasySetup Configuration page into the input tray face
down.
2. Scan the document.
The scanner will read the barcode and set the scanner up per the
predetermined configuration settings.
To Next Page
Loading...
