Kodak ScanMate i1150WN - Using the Special Easysetup Configuration Page

2-30 A-61854 April 2016
Using the special
EasySetup Configuration
page
The following options are available on the EasySetup Configuration
page.
EasySetup page description — the description in this field will be
printed at the top of the EasySetup page. This description should be a
message that informs the user what you want them to do. For example,
if you create an EasySetup Configuration page to restore factory
defaults, the description in this field should be something like Restore
factory defaults.
Apply these to: any scanner — if checked, the EasySetup
configuration will be applied to a scanner without checking the serial
number of that scanner first. This is useful in cases where a
configuration is being copied to several scanners using one master
configuration. This can be done many times when you are configuring
scanners to work on a Wireless Network network.
NOTE: Static addresses or the access point SSID are not allowed to be
applied using the Apply these to: any Scanner option
, but they
are allowed when applied to a specific S/N. This enables you to
configure each scanner for static information specific to that one
scanner.
Apply these to: specific to S/N — enter a serial number of a specific
scanner that you want to apply these EasySetup configuration settings
to in this field. This is important when you are specifying parameters
like Access Point SSID or Static IP, where if they are duplicated, the
scanner will not work as expected and should not be copied to several
scanners. The serial number you enter in this field MUST match the
serial number that is displayed in the Wireless Access Point SSID field
of the scanner which will use the EasySetup Configuration page.
NOTE: Static addresses or the access point SSID are not allowed to be
applied using the Apply these to: any Scanner option.
Apply Admin password — if selected, the password entered in this
field will be applied to the scanner as the admin password. This works
the same way as if you created a password using the Change Admin
Password option on the Support tab. This password will be applied
when the EasySetup page is scanned in EasySetup mode on the
scanner Operator Control Panel. Assigning a password will protect the
configuration from an end user so they cannot make changes.