4-8 A-61854 April 2016
Cleaning the imaging
guides
1. Gently wipe the upper and lower imaging guide using a Brillianze
Detailer wipe (Step 1) or Staticide wipe. Be careful not to scratch the
imaging area when cleaning.
IMPORTANT: Staticide wipes contain isopropanol which can cause eye
irritation and dry skin. Wash your hands with soap and
water after performing maintenance procedures. Refer to
the SDS for more information.
2. Wipe the upper and lower imaging guide again using a Brillianize
wipe (Step 2) or an almost dry Staticide wipe to remove any streaks.
3. When finished, close the scanner cover.
Running a transport
cleaning sheet
In addition to regular cleaning procedures, you can run a transport
cleaning sheet. Transport cleaning sheets are available for purchase.
See the section entitled, “Supplies and Consumables” later in this
chapter for more information.
1. Remove the wrapping from the Transport Cleaning Sheet.
2. Adjust the side guides to fit the cleaning sheet.
3. Place a transport cleaning sheet in the input tray (adhesive side
facing you) in portrait orientation.
4. Scan the transport cleaning sheet.
5. After the transport cleaning sheet is scanned, turn it over (adhesive
side facing the input tray) and scan it again.
6. Open the scanner cover and wipe the imaging area with a lint-free
cloth.
7. Close the scanner cover.
8. Check your image quality.
9. If necessary, repeat this procedure until all residue is removed from
the rollers.
NOTE: When a transport cleaning sheet gets very dirty, discard it and
use a new one.
To Next Page
Loading...
