1-6 A-61854 April 2016
Back view
1 Power port — connects the power supply to the scanner.
2
USB port — connects the scanner to the PC using a USB
cable.
3
Ethernet port — connects the scanner to the network
using an Ethernet cable (not provided by Kodak Alaris).
4
Security lock port — connects a security lock to the
scanner. You can purchase a standard security lock at an
office supply store. Refer to the instructions provided with
the security lock for installation procedures.
5
Wireless switch — toggles the wireless capability OFF
and ON. When the switch is to the right, the wireless
capability is ON; when the switch is to the left, wireless is
OFF.
6
Reset — resets the scanner configuration to the factory
defaults.
To reset the scanner to factory defaults:
• Power off scanner.
• Press and hold the Reset button.
• Continue to press and hold the Reset button and power
on the scanner until the message, Scanner has been
reset is displayed on the Operator Control Panel.
To Next Page
Loading...
