A-61854 April 2016 2-17
Optional: EasySetup
1. Click Print EasySetup. The EasySetup Configuration page will be
displayed.
2. Enter a description in the EasySetup page description field.
3. Select how you want to apply these settings: to any scanner or a
specific scanner. If you select specific to S/N, you must enter the
serial number of the scanner you want to save these settings to.
4. If you want to apply a password, check the Apply Admin password
box and enter the password.
NOTE: For a description of the settings on this page, see the section
entitled, “Using the special EasySetup Configuration page” later
in this chapter.
5. Select Generate EasySetup PDF.
6. Print the EasySetup Configuration page by right-clicking on the
page and selecting Print.
7. Place the EasySetup Configuration page into the scanner’s input
tray and press and hold the i button for 4 seconds on the Operator
Control Panel. The message, In use by EasySetup will be
displayed on the Operator Control Panel.
8. Press the Scan button on the scanner. The scanner will be
configured using the settings from the EasySetup Configuration
page.
NOTE: If needed, you can send this document to remote scanner
users. Each scanner user, will need to scan the EasySetup
Configuration page. Each scanner will be configured using the
settings from the EasySetup Configuration page.
To Next Page
Loading...
