Koden MDC-1840BB - Chapter 4 Installation

MDC-1840BB/1841BB/1860BB/1810BB/1820BB Series Chapter 4
Operation Manual Installation
93142122-07 Contents
Chapter 4
Installation
Contents
Page No.
4.1 Installation considerations...................................................... 4-1
4.2 Unpacking each component of the system............................ 4-1
4.3 Inspection of each component unit and accessories........... 4-1
4.4 Setting the units ....................................................................... 4-1
4.4.1 Antenna Unit........................................................................................4-1
4.4.2 Processor Unit and Operation Unit......................................................4-2
4.5 Cable routing and connections............................................... 4-2
4.5.1 Antenna...............................................................................................4-2
4.5.2 Processor Unit.....................................................................................4-3
4.6 Installation procedure.............................................................. 4-3
4.6.1 Installing the Transceiver Unit..............................................................4-3
4.6.2 Fitting the Aerial...................................................................................4-4
4.6.3 Connecting the cable...........................................................................4-5
4.6.4 Installing the Processor Unit................................................................4-6
4.6.5 Installing the Operation Unit ................................................................4-8
4.6.5.1 Table mounting..........................................................................4-8
4.6.5.2 Flush mounting .......................................................................4-10
4.6.6 Connecting the cable to the Display unit ...........................................4-12
4.6.7 Link setting for the gyrocompass.......................................................4-13
4.6.8 Ferrite core assembling for Power cable .............................................4-14
4.7 Setting up after installation ................................................... 4-15
4.7.1 Auto tune adjustment.........................................................................4-15
4.7.2 Transmission timing...........................................................................4-16
4.7.3 Ship’s heading setup .........................................................................4-17
4.7.4 Resetting Manual GAIN/STC (Height)/Manual STC ..........................4-17
4.7.4.1 Manual GAIN setting...............................................................4-17
4.7.4.2 STC (Height) setting ...............................................................4-18
4.7.4.3 Manual STC setting ................................................................4-19