Kohler MPAC 1500 - Page 4

Table of Contents, continued
TP-6714 4/10Table of Contents4
3.9 Sequence of Operation, Closed Transition Models 32.........................
3.9.1 Preferred Source Loss and Return, Closed-Transition 32..............
3.9.2 Failure to Synchronize (Programmed-Transition Override) 32..........
3.9.3 Exerciser Operation, Closed-Transition 33...........................
3.9.4 Test Sequence, Closed-Transition 33...............................
3.10 System Test 35..........................................................
3.10.1 Unloaded System Test 36.........................................
3.10.2 Loaded System Test 36...........................................
3.10.3 Closed-Transition Loaded Test 36..................................
3.10.4 Auto-Loaded System Test 37......................................
3.10.5 Sync Check (closed-transition) 37..................................
3.11 Lamp Test 38............................................................
3.12 Exercise 38.............................................................
3.12.1 Unloaded Exercise 38............................................
3.12.2 Load Bank Control 38............................................
3.12.3 Loaded Exercise 38..............................................
3.13 Warnings and Faults 39...................................................
3.13.1 Fault Reset 40...................................................
3.14 Accessory Module Faults 40...............................................
3.14.1 Module Status Change 40.........................................
3.14.2 Module Status Conflict 41.........................................
3.15 Reset Data 42...........................................................
3.15.1 Reset Maintenance Records 42....................................
3.15.2 Reset Event History 42...........................................
3.15.3 Reset Default Parameters 42......................................
3.15.4 Reset and Disable Test P assword 44...............................
3.15.5 File Maintenance 44..............................................
Section 4 View Screens 45...................................................................
4.1 Introduction 45..........................................................
4.2 Main Screen 45..........................................................
4.3 View Screens 45.........................................................
4.4 View Event History 46....................................................
4.5 View Maintenance Records 46.............................................
4.6 View Exerciser Setup 47..................................................
4.7 View Prime Power Setup 47...............................................
4.8 View System Setup 47....................................................
4.9 View Source Setup 48....................................................
4.10 View Time Delays, Source 1 50............................................
4.11 View Time Delays, Source 2 52............................................
4.12 View Inputs/Outputs 54...................................................
4.13 View Common Alarms 54.................................................
4.14 View Communications Setup 55...........................................
4.15 View Control Parameters 55...............................................
Section 5 Setup 57...........................................................................
5.1 Introduction 57..........................................................
5.2 Source Names 57........................................................
5.3 Controller DIP Switches 57................................................
5.4 Default Settings and Time Delays 58.......................................
5.4.1 System Parameters 58............................................
5.4.2 Time Delays 58..................................................
5.5 Setup Screens 59........................................................
5.6 Time/Date 60............................................................