Kohler MPAC 1500 - Page 5

Table of Contents, continued
TP-6714 4/10 Table of Contents 5
5.7 Exerciser 61.............................................................
5.7.1 Setting the Exerciser 61...........................................
5.7.2 Source/Source Mode 61..........................................
5.8 Prime Power Run 63.....................................................
5.8.1 Prime Power Mode Setup 63......................................
5.8.2 Prime Power Mode Operation 63...................................
5.9 Time Delays 64..........................................................
5.9.1 Time Delays 64..................................................
5.9.2 Load Control Time Delays 64......................................
5.9.3 Set S1 Time Delays 65...........................................
5.9.4 Set S2 Time Delays 67...........................................
5.10 Load Control 69.........................................................
5.10.1 Time-Based Load Control 69......................................
5.10.2 Current-Based Load Control 71....................................
5.11 Source Setup 73.........................................................
5.11.1 Phase Rotation 73...............................................
5.11.2 In-Phase Monitor 73..............................................
5.11.3 Preferred Source Selection 73.....................................
5.11.4 System Voltage and Frequency 74.................................
5.11.5 Voltage and Frequency Pickup and Dropout Settings 75...............
5.11.6 Set Sources 76..................................................
5.12 Programmable Inputs and Outputs 79......................................
5.12.1 Main Logic Board Inputs and Outputs 79............................
5.12.2 Input/Output Modules 79..........................................
5.12.3 Input Functions 80...............................................
5.12.4 Output Functions 81..............................................
5.12.5 User-Defined I/O Function Descriptions 82..........................
5.13 Common Alarms 83......................................................
5.13.1 Common Alarm Output 83.........................................
5.13.2 Audible Alarm 83.................................................
5.13.3 Chicago Alarm 83................................................
5.14 Set System 84...........................................................
5.14.1 Source Type/Source Type 84......................................
5.14.2 Transition Type 84...............................................
5.14.3 Service Entrance 84..............................................
5.14.4 Rated Current 84................................................
5.14.5 Three Source Engine Start Mode 84................................
5.14.6 Transfer Commit 84..............................................
5.14.7 Remote Test Loading 85..........................................
5.14.8 Peak Shave TD Bypass 85........................................
5.14.9 USB Data Logger 85.............................................
5.14.10 Min/Max Values 85...............................................
5.15 Three-Source Systems 87.................................................
5.15.1 Three Source Engine Start Mode 87................................
5.15.2 Preferred Source Toggle 87.......................................
5.15.3 Three Source System Test and Exercise 87.........................
5.15.4 Three-Source System Setup 87....................................
5.15.5 ATS1 and ATS2 System Setup 88..................................
5.16 Communications 91......................................................
5.17 Set Passwords 91........................................................
5.18 Calibration 92
...........................................................
Section 6 Communications 93................................................................
6.1 Introduction 93..........................................................