88
CONNECTING THE CAMERA TO A COMPUTER
Confirm the battery has the sufficient power before connecting the camera to a computer.
The use of the AC adapter (sold separately) is recommended over the use of the battery.
For users with Windows 98 or 98SE, read the section on page 90 on how to install the
necessary USB driver before connecting the camera to a computer.
5.Turn on the camera to initiate the USB connec-
tion. While the camera is connected to a comput-
er, the data-transfer screen will be displayed.
4.Attach the other end of the USB cable to the computer’s
USB port. Make sure the plug is firmly attached. The cam-
era should be connected directly to the comput-
er’s USB port. Attaching the camera to a USB hub
may prevent the camera from operating properly.
3.Slide the USB-port cover open. Insert the small plug of the
USB cable into the camera. Make sure the plug is firmly
attached.
1.Start up the computer. The computer must be turned on
before connecting the camera.
2.Insert the memory card into the camera. To change the
memory card while the camera is connected to a comput-
er, see page 98.
DATA-TRANSFER MODE
To Next Page
Loading...
