96 DATA-TRANSFER MODE
DISCONNECTING THE CAMERA FROM A COMPUTER
Windows Me, 2000 Professional, and XP
Confirm that the indicator lamp is not lit. Turn the camera off, and then disconnect the
USB cable.
To disconnect the camera, click once on the unplug-or-eject-hardware icon
located on the task bar. A small window will open indicating the device to be
stopped.
Windows 98 / 98 Second Edition
When more than one external device are connected to the computer, repeat the
procedure above except right click on the unplug-or-eject-hardware icon. This will open
the unplug-or-eject-hardware window after clicking on the small window indicating the
unplug-or-eject-hardware routine.
Click on the small window to stop
the device. The safe-to-remove-
hardware window will open. Close
the window, turn the camera off,
and then disconnect the USB
cable.
Never disconnect the camera when the indicator lamp is red - the data
or memory card may permanently be damaged.
To Next Page
Loading...
