Korg R3 - Vocoder Program Structure; Vocoder Section Explanation; Modulator and Carrier Signal Roles

Effect guide
8
B2 Q [00.5…10.0]
Sets the bandwidth of Band 2. This parameter will be
displayed and can be set if “B1 Type” is Peaking.
B2 Gain [–18.0…+18.0dB]
Sets the gain of Band 2.
B3 Freq (B3 Frequency)
only MFX
[20Hz…20.0kHz]
Sets the center frequency of Band 3.
B3 Q
only MFX
[00.5…10.0]
Sets the bandwidth of Band 3.
B3 Gain
only MFX
[–18.0…+18.0dB]
Sets the gain of Band 3.
B4 Freq (B4 Frequency)
only MFX
[20Hz…20.0kHz]
Sets the center frequency of Band 4.
B4 Q
only MFX
[00.5…10.0]
Sets the bandwidth of Band 4.
B4 Gain
only MFX
[–18.0…+18.0dB]
Sets the gain of Band 4.
7. Distort (Distortion)
This is a distortion effect with a three band EQ, giving
you a broad range of variations.
Gain [000…127]
Sets the degree of distortion.
Pre Freq (Pre EQ Frequency) [20Hz…20.0kHz]
Sets the center frequency of Pre EQ.
Pre Q (Pre EQ Q) [00.5…10.0]
Sets the bandwidth of Pre EQ.
Pre Gain (Pre EQ Gain) [–18.0…+18.0dB]
Sets the gain of Band PreEQ.
B1 Freq (B1 Frequency) [20Hz…20.0kHz]
Sets the center frequency of Band 1.
B1 Q [00.5…10.0]
Sets the bandwidth of Band 1.
B1 Gain [–18.0…+18.0dB]
Sets the gain of Band 1.
B2 Freq (B2 Frequency) [20Hz…20.0kHz]
Sets the center frequency of Band 2.
B2 Q [00.5…10.0]
Sets the bandwidth of Band 2.
B2 Gain [–18.0…+18.0dB]
Sets the gain of Band 2.
B3 Freq (B3 Frequency) [20Hz…20.0kHz]
Sets the center frequency of Band 3.
B3 Q [00.5…10.0]
Sets the bandwidth of Band 3.
B3 Gain [–18.0…+18.0dB]
Sets the gain of Band 3.
OutLevel (Output Level) [000…127]
Sets the output level.
Left
Right
Dry / Wet
Dry / Wet
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
3 Band PEQ
Output Level
Pre EQ
Distortion