Effect parameters
19
22. S.Flangr (Stereo Flanger/Comb Filter)
This effect gives a significant swell and movement of
pitch to the sound. It is more effective when applied to a
sound with a lot of harmonics. This is a stereo flanger.
You can add spread to the sound by offsetting the phase
of the left and right LFOs from each other. This effect can
also be used as a comb filter.
Type [Flanger, Comb]
Switches the effect between flanger and comb filter.
Delay [00.0…30.0msec]
Sets the delay time in millisecond steps when “Type” is
set to Flanger.
If this parameter is assigned to “Fx Knob,” setting
“Type” to Comb will switch the assignment to
Cutoff.
Cutoff (Cutoff Frequency) [000…127]
When “Type” is set to Comb, this sets the cutoff frequen-
cy of the comb filter.
ModDepth (Modulation Depth) [000…127]
Sets the depth of LFO modulation.
Feedback [000…127]
Sets the amount of feedback for the left and right chan-
nels.
Phase [+, –]
When “Type” is set to Flanger, this switches the phase of
the output and feedback.
LFO Sync (LFO BPM Sync) [Off, On]
Specifies whether the internal LFO cycle will be syn-
chronized with the tempo specified by the [TEMPO]
knob or MIDI clock.
☞ p.5 “LFO Sync (LFO BPM Sync)”
LFO Freq (LFO Frequency) [0.01…100.0Hz]
Sets the LFO speed if “BPM Sync” is Off.“
☞ p.5 “LFO Freq (LFO Frequency)”
SyncNote (LFO SyncNote) [8/1…1/64]
Sets the LFO frequency as a proportion of the tempo set
by the [TEMPO] knob. This parameter will be displayed
and can be set if “BPM Sync” is On.“
☞ p.5 “SyncNote (LFO SyncNote)”
LFO Wave (LFO Waveform)
[Saw, Square, Triangle, Sine, S&H]
Selects the internal LFO waveform.
☞ p.5 “LFO Wave (LFO Waveform)”
LFOShape (LFO Shape) [–63…+63]
Adjusts the shape of the internal LFO waveform.
☞ p.5 “LFOShape”
Key Sync (LFO KeySync) [Off, Timbre]
Specifies whether the LFO will be reset by note-on.
☞ p.5 “Key Sync (LFO KeySync)”
IniPhase (LFO Init Phase) [000…180°]
Sets the starting location of the waveform if “Key Sync”
is Timbre.
☞ p.5 “IniPhase (LFO Init Phase)”
LFO Spred (LFO Spread) [–180…180°]
Sets the LFO phase difference between the left and right
channels.
HighDamp [000…100%]
Sets the feedback damping amount in the high range if
the “Type” is Flanger.
Flanger
Flanger
Left
Right
Feedback
LFO Shape
LFO Spread
LFO
Dry / Wet
Dry / Wet
High Damp (Type: Flanger)
Stereo In - Stereo Out
To Next Page
Loading...
