Korg R3 Effect Guide

Effect guide
2
0
23. S.Phaser (Stereo Phaser)
This effect creates a swell by shifting the phase. It is very
effective on electric piano sounds. You can add spread
to the sound by offsetting the phase of the left and right
LFOs from each other.
Type [Blue, U-VB]
Selects the phaser type.
Manual [000…127]
Sets the frequency to which the effect is applied.
ModDepth (Modulation Depth) [000…127]
Sets the depth of the internal LFO modulation.
Resonanc (Resonance) [000…127]
Sets the resonance amount.
Phase [+, –]
Switches the phase of the output and feedback.
LFO Sync (LFO BPM Sync) [Off, On]
Specifies whether the internal LFO cycle will be syn-
chronized with the tempo specified by the [TEMPO]
knob or MIDI clock.
☞ p.5 “LFO Sync (LFO BPM Sync)”
LFO Freq (LFO Frequency) [0.01…100.0Hz]
Sets the LFO speed if “BPM Sync” is Off.
☞ p.5 “LFO Freq (LFO Frequency)”
SyncNote (LFO SyncNote) [8/1…1/64]
Sets the LFO frequency as a proportion of the tempo set
by the [TEMPO] knob if “BPM Sync” is On.
☞ p.5 “SyncNote (LFO SyncNote)”
LFO Wave (LFO Waveform)
[Saw, Square, Triangle, Sine, S&H]
Selects the internal LFO waveform.
☞ p.5 “LFO Wave (LFO Waveform)”
LFO Shape [–63…+63]
Adjusts the shape of the internal LFO waveform.
☞ p.5 “LFOShape”
Key Sync (LFO KeySync) [Off, Timbre]
Specifies whether the LFO will be reset by note-on.
☞ p.5 “Key Sync (LFO KeySync)”
IniPhase (LFO Init Phase) [000…180°]
Sets the starting location of the waveform if “Key Sync” is
Timbre.
☞ p.5 “IniPhase (LFO Init Phase)”
LFO Spred (LFO Spread) [–180…+180°]
Sets the LFO phase difference between the left and right
channels.
HighDamp [000…100%]
Sets the feedback damping amount in the high range.
Left
Right
Resonance
LFO Shape
LFO Spread
LFO
Dry / Wet
Dry / Wet
High Damp
Stereo In - Stereo Out
Phaser
Phaser

Korg R3 Specifications

General

Brand	Korg
Model	R3
Category	Synthesizer
Language	English