Korg R3 Effect Guide

Effect guide
2
2
SyncNote (LFO SyncNote) [8/1…1/64]
Sets the LFO frequency as a proportion of the tempo set
by the [TEMPO] knob if “BPM Sync” is On.
☞ p.5 “SyncNote (LFO SyncNote)”
LFO Wave (LFO Waveform)
[Saw, Square, Triangle, Sine, S&H]
Selects the LFO waveform.
☞ p.5 “LFO Wave (LFO Waveform)”
LFOShape (LFO Shape) [–63…+63]
Adjusts the shape of the internal LFO waveform.
☞ p.5 “LFOShape”
Key Sync (LFO Key Sync) [Off, Timbre]
Specifies whether the LFO will be reset by note-on.
☞ p.5 “Key Sync (LFO KeySync)”
IniPhase (LFO Init Phase) [000…180°]
Sets the starting location of the waveform if “Key Sync”
is Timbre.
☞ p.5 “IniPhase (LFO Init Phase)”
Pre LPF [000…127]
This parameter enables you to set the damping amount
of the high range sound input to the ring modulator. If
the input sound contains lots of harmonics, the effect
may sound dirty. In this case, cut a certain amount of
high range.
26. PitchSft (Pitch Shifter): IFX
S.PtcShft
(Stereo Pitch Shifter): MFX
This effect changes the pitch of the input signal. You can
select from three types: Fast (quick response), Medium,
and Slow (preserves tonal quality). You can also create
an effect in which the pitch is gradually raised (or
dropped) using the delay with feedback.
If used for an insert effect, this will be mono-in/mono-
out.
If used for the master effect, this will be stereo-in/ste-
reo-out.
Pitch (Pitch Shift) [–24…+24]
Sets the pitch shift amount by steps of a semitone.
Fine [–100…+100]
Sets the pitch shift amount by steps of a cent.
BPM Sync (DelayTime BPM Sync)
only MFX
[Off, On]
Specifies whether the delay time will be synchronized.
☞ p.13 LCR Delay “BPM Sync (Delay Time BPM Sync)”
TimRatio (Time Ratio)
only MFX
[BPM Sync Off: 000.5…400.0% (OVER)
BPM Sync On: 012.5…400.0% (OVER)]
☞ p.13 LCR Delay “TimRatio (Time Ratio)”
Delay (Delay Time)
only MFX
[BPM Sync Off: 000…500msec
BPM Sync On: 1/64… 1/1]
If “BPM Sync” is Off, this delay time is set in msec units.
If “BPM Sync” is On, this delay time is set as a timing
resolution relative to the tempo specified by the [TEM-
PO] knob or MIDI clock.
FB Pos (FeedBack Position)
only MFX
[Pre, Post]
Switches the feedback connection.
Feedback
only MFX
[000…127]
Sets the feedback amount.
Mode [Slow, Medium, Fast]
This parameter selects the pitch shifter operating mode.
With Slow, tonal quality will not be changed too much.
With Fast, the effect becomes a Pitch Shifter that has a
quick response, but may change the tone. Medium is in
Left
Right
Dry / Wet
Dry / Wet
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Input Level
Input Level
+
High Damp
Delay
Pitch Shifter
Insert FX
Left
Right
Feedback
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
High Damp
High Damp
Trim
Trim
Feedback Position
Pre
Pre
Post
Post
Delay
Pitch Shifter
Delay
Pitch Shifter
Master FX

Korg R3 Specifications

General

Brand	Korg
Model	R3
Category	Synthesizer
Language	English