Effect guide
12
Trim (Pre EQ Trim)
only MFX
[000…127]
Sets the EQ input level.
LoEQGain (Low EQ Gain)
only MFX
[–15.0…+15.0dB]
Sets the gain of Low EQ.
HiEQGain (High EQ Gain)
only MFX
[–15.0…+15.0dB]
Sets the gain of High EQ.
ER Level
only MFX
[000…127]
Sets the time taken from the original sound to the first
early reflection. When used for the master effect, this is
displayed and can be set only if Room or BritRoom is se-
lected.
Rev Level (Reverb Level)
only MFX
[000…127]
Sets the reverberation level. When used for the master
effect, this is displayed and can be set only if Room or
BritRoom is selected.
12. EarlyRef (Early Reflections)
This effect is only the early reflection part of a reverber-
ation sound, and adds presence to the sound. You can
select one of the four decay curves.
Type [Sharp, Loose, Modulate, Reverse]
Selects the decay curve for the early reflection.
ER Time [IFX: 010…400msec/MFX: 010…800msec]
Sets the time from the original sound to the first early re-
flection. The range of this parameter will differ depend-
ing on whether the effect is an insert effect or a master
effect.
PreDelay [IFX: 000…100msec/MFX: 000…200msec]
Sets the time taken from the original sound to the first
early reflection. The range of this parameter will differ
depending on whether the effect is an insert effect or a
master effect.
Trim (Pre EQ Trim) [000…127]
Sets the input level of EQ applied to the effect sound.
LoEQGain (Low EQ Gain)
only MFX
[–15.0…+15.0dB]
Sets the gain of Low EQ.
HiEQGain (High EQ Gain)
only MFX
[–15.0…+15.0dB]
Sets the gain of High EQ.
HighDamp
only IFX
[000…100%]
Sets the damping amount in the high range.
Low Damp
only IFX
[000…100%]
Sets the damping amount in the low range.
Left
Right
Dry / Wet
Dry / Wet
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
EQ Trim
+
EQ Trim
Pre Delay
Early Reflections
IFX: Low Damp
MFX: LEQ
IFX: High Damp
MFX: HEQ
Sharp
Loose
Modulated
Early Reflections - Type
Reverse
Dry
Pre Delay
ER Time
To Next Page
Loading...
