Korg R3 Effect Guide

Effect parameters
17
18. S.ModDly (Stereo Modulation Delay)
This is a stereo modulation delay.
BPM Sync (DelayTime BPM Sync) [Off, On]
Specifies whether the delay tempo will be synchronized.
☞ p.13 LCR Delay “BPM Sync (Delay Time BPM Sync)”
TimRatio (Time Ratio)
[BPM Sync Off: 000.5…400.0% (OVER)
BPM Sync On: 012.5…400.0% (OVER)]
☞ p.13 LCR Delay “TimRatio (Time Ratio)”
L Delay, R Delay (L, R Delay Time)
[BPM Sync Off IFX: 000…480msec
BPM Sync Off MFX: 000…680msec
BPM Sync On 1/64…1/1]
☞ p.14 StDelay “L Delay, R Delay (L, R Delay Time)”
Feedback [000…127]
☞ p.14 StDelay “Feedback”
ModDepth (Modulation Depth) [000…127]
Sets the depth of internal LFO modulation.
LFO Freq (LFO Frequency) [0.01…100.0Hz]
Sets the internal LFO speed. Increasing this value will
result in a faster frequency.
LFO Spred (LFO Spread) [–180…+180°]
Sets the phase difference between the left and right
channels.
19. TapeEcho
This effect simulates a tape echo unit. The distortion and
tonal change typical of magnetic tape are also repro-
duced.
BPM Sync (DelayTime BPM Sync) [Off, On]
Specifies whether the delay tempo will be synchronized.
☞ p.13 LCR Delay “BPM Sync (Delay Time BPM Sync)”
TimRatio (Time Ratio)
[BPM Sync Off: 000.5…400.0% (OVER)
BPM Sync On: 012.5…400.0% (OVER)]
☞ p.13 LCR Delay “TimRatio (Time Ratio)”
Tap1Delay, Tap2 Delay(Tap1, Tap2 Delay Time)
[BPM Sync Off IFX: 000…980msec
BPM Sync Off MFX: 0000…1380msec,
BPM Sync On: 1/64… 1/1]
Sets the delay times for Tap1 and Tap2.
☞ p.13 LCR Delay “L Delay, C Delay, R Delay (L, C, R
Delay Time)”
Tap1Lvl, Tap2 Lvl (Tap1 Level, Tap2 Level) [000…127]
Sets the Tap1 output level and Tap2 output level.
Feedback [000…127]
Sets the Tap1 feedback amount.
HighDamp [000…100%]
Sets the damping amount in the high range.
Low Damp [000…100%]
Sets the damping amount in the low range.
Trim [000…127]
Sets the input level.
Saturatn (Saturation) [000…127]
Sets the distortion amount.
Waw Freq (Wah Flutter Frequency) [0.01…100.0Hz]
Sets the frequency at which pitch variation will occur in
Hz stepsl.
WawDepth (Wah Flutter Depth) [000…127]
Sets the depth of pitch variation.
Pre Tone [000…127]
Sets the tone of the input.
Spread [000…127]
Sets the width of the stereo image of the effect sound.
☞ p.13 LCR Delay “Spread”
Left
Right
Feedback
LFO Spread
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
Delay
Delay
LFO
Wah Flutter
Tap2 Level
+
Tape
Saturation
Left
Right
Dry / Wet
Trim
Tape1 Level
Dry / Wet
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Feedback
High / Low Damp
Pre Tone
Delay
Spread

Korg R3 Specifications

General

Brand	Korg
Model	R3
Category	Synthesizer
Language	English