Effect parameters
15
Key Sync (LFO Key Sync) [Off, Timbre]
Specifies whether the LFO will be reset by note-on.
☞ p.5 “Key Sync (LFO KeySync)”
IniPhase (LFO Init Phase) [000…180°]
Sets the starting location of the waveform if “Key Sync”
is Timbre.
☞ p.5 “IniPhase (LFO Init Phase)”
High Damp [000…100%]
Sets the damping amount in the high range.
Low Damp [000…100%]
Sets the damping amount in the low range.
Trim [000…127]
Sets the input level.
16. S.APnDly (Stereo Auto Panning Delay)
This is a stereo delay that uses an LFO to pan the delay
sound between left and right.
BPM Sync (DelayTime BPM Sync) [Off, On]
Specifies whether the delay tempo will be synchronized.
☞ p.13 LCR Delay “BPM Sync (Delay Time BPM Sync)”
TimRatio (Time Ratio)
[BPM Sync Off: 000.5…400.0% (OVER)
BPM Sync On: 012.5…400.0% (OVER)]
☞ p.13 LCR Delay “TimRatio (Time Ratio)”
L Delay, R Delay (L, R Delay Time)
[BPM Sync Off IFX: 000…500msec
BPM Sync Off MFX: 000…700msec
BPM Sync On: 1/64…1/1]
These set the left and right channel delay times.
☞ p.14 StDelay “L Delay, R Delay (L, R Delay Time)”
Feedback [000…127]
Sets the feedback amount for the left channel.
☞ p.14 StDelay “Feedback”
ModDepth (Modulation Depth) [000…127]
Sets the depth of modulation.
LFO Sync (LFO BPM Sync) [Off, On]
Specifies whether the internal LFO cycle will be syn-
chronized with the tempo specified by the [TEMPO]
knob or MIDI clock.
☞ p.5 “LFO Sync (LFO BPM Sync)”
LFO Freq (LFO Frequency) [0.01…100.0Hz]
Sets the LFO speed if “BPM Sync” is Off.
☞ p.5 “LFO Freq (LFO Frequency)”
SyncNote (LFO SyncNote) [8/1…1/64]
Sets the LFO frequency as a proportion of the tempo set
by the [TEMPO] knob if “BPM Sync” is On.
☞ p.5 “SyncNote (LFO SyncNote)”
LFO Wave (LFO Waveform)
[Saw, Square, Triangle, Sine, S&H]
Selects the internal LFO waveform.
☞ p.5 “LFO Wave (LFO Waveform)”
LFOShape (LFO Shape) [–63…+63]
Adjusts the shape of the internal LFO waveform.
☞ p.5 “LFOShape”
Key Sync (LFO Key Sync) [Off, Timbre]
Specifies whether the LFO will be reset by note-on.
☞ p.5 “Key Sync (LFO KeySync)”
Left
Right
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
LFO Spread
LFO Shape
Pan
Pan
LFO
Depth
Delay
Delay
High Damp Low Damp
High Damp
Low Damp
Feedback
Trim
Trim