Korg R3 Effect Guide

Effect guide
2
4
LFO Sync (LFO BPM Sync) [Off, On]
Specifies whether the internal LFO cycle will be syn-
chronized with the tempo specified by the [TEMPO]
knob or MIDI clock.
☞ p.5 “LFO Sync (LFO BPM Sync)”
LFO Freq (LFO Frequency) [0.01…100.0Hz]
If “BPM Sync” is Off, this specifies the cycle at which the
waveform is switched in Hz units. The waveform length
specified by “Duration” will play as a loop, and the
waveform will switch at each cycle of the internal LFO.
If this parameter is assigned to “Fx Knob,” turning
“BPM Sync” On will switch the assignment to Syn-
cNote.
SyncNote (LFO Sync Note) [8/1…1/64]
Sets the internal LFO frequency as a proportion of the
tempo set by the [TEMPO] knob if “BPM Sync” is On.
☞ p.5 “SyncNote (LFO SyncNote)”
Key Sync (LFO Key Sync) [Off, Timbre]
Specifies whether the LFO will be reset by note-on.
☞ p.5 “Key Sync (LFO KeySync)”
IniPhase (LFO Init Phase) [000…180°]
Sets the starting location of the waveform if “Key Sync”
is Timbre.
☞ p.5 “IniPhase (LFO Init Phase)”
LFOSpread (LFO Spread)
only MFX
[–180…+180°]
Sets the phase difference between the left and right
channels. When used for the master effect, this is dis-
played and can be set this parameter.
28. S.Vibart (Stereo Vibrato)
This effect causes the pitch of the input signal to shim-
mer. Using the AutoFade allows you to increase or de-
crease the shimmering speed.
ModDepth (Modulation Depth) [000…127]
Sets the depth of internal LFO modulation.
LFO Sync (LFO BPM Sync) [Off, On]
Specifies whether the internal LFO cycle will be syn-
chronized with the tempo specified by the [TEMPO]
knob or MIDI clock.
☞ p.5 “LFO Sync (LFO BPM Sync)”
LFO Freq (LFO Frequency) [0.01…100.0Hz]
Sets the LFO speed.
☞ p.5 “LFO Freq (LFO Frequency)”
SyncNote (LFO Sync Note) [8/1…1/64]
Sets the internal LFO frequency as a proportion of the
tempo set by the [TEMPO] knob if “BPM Sync” is On.
☞ p.5 “SyncNote (LFO SyncNote)”
LFO Wave (LFO Waveform)
[Saw, Square, Triangle, Sine, S&H]
Selects the internal LFO waveform.
☞ p.5 “LFO Wave (LFO Waveform)”
LFOShape (LFO Shape) [–63…+63]
☞ p.5 “LFOShape”
Key Sync (LFO Key Sync) [Off, Timbre]
Specifies whether the internal LFO will be reset by note-
on.
☞ p.5 “Key Sync (LFO KeySync)”
IniPhase (LFO Init Phase) [000…180°]
Sets the starting location of the waveform if “Key Sync”
is Timbre.
☞ p.5 “IniPhase (LFO Init Phase)”
LFOSpred (LFO Spread)
only MFX
[–180…180°]
Sets the LFO phase difference between the left and right
channels.
In
Out
LFO Cycle /Duration
LFO Cycle
Duration
Vibrato
Vibrato
Left
Right
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
LFO
LFO Shape
LFO Spread

Korg R3 Specifications

General

Brand	Korg
Model	R3
Category	Synthesizer
Language	English