31
Knob [1]
OSC1 Lvl (OSC1 Level) [000...127]
Sets the output level of oscillator 1.
Knob [2]
OSC2 Lvl (OSC2 Level) [000...127]
Sets the output level of oscillator 2.
Knob [3]
NoiseLvl (Noise Level) [000...127]
Sets the output level of the noise genera-
tor. This noise generator generates white
noise. This is independent of the white
noise that can be selected as a waveform
for oscillator 1(“Wave”: Noise.) This does
not have filter or resonance as the oscilla-
tor 1 noise generator does, but you can use
the FILTER section to create the same re-
sults as the noise waveform of oscillator 1.
Noise is used to create percussion instru-
ment sounds, or sound effects such as surf.
Knob [4]
PunchLvl (Punch Level) [000…127]
Creates a more “snappy” attack by adjust-
ing the amount of pulse waveform that is
added to the oscillator output only during
the attack. Increasing this value will em-
phasize the attack.
7. MIXER
These parameters adjust the volume balance of the oscillator 1 and 2, and the noise generator. These settings will be the input level to the filter
section.
To Next Page
Loading...
