Korg R3 - Eg3

42
16. EG3
Here you can adjust the settings of EG3. Create the desired curve by adjusting the ADSR parameters; ATTACK (knob [1]), DECAY (knob [2]),
SUSTAIN (knob [3]), RELEASE (knob [4]).
You can use EG3 as a Virtual Patch source to modulate parameters other than filter cutoff (EG1) or volume (EG2). (☞p.45)
Knob [1]
Attack3 (Attack EG3) [000...127]
Specifies the time from note-on (when the
key is pressed) until the attack level (maxi-
mum value of the envelope) is reached.
Knob [2]
Decay3 (Decay EG3) [000...127]
Specifies the time from when the attack
level is reached until the sustain level (SUS-
TAIN) is reached.
Knob [3]
Sustain3 (Sustain EG3) [000...127]
Specifies the volume that will be main-
tained after the decay time has elapsed, as
long as you continue holding the key.
Knob [4]
Release3 (Release EG3) [000...127]
Specifies the time from note-off (when the
key is released) until the level reaches 0.