Korg R3 - Insert Fx1, 30 Insert Fx2

49
29. INSERT FX1, 30 INSERT FX2
These are the settings for insert effect 1 and insert effect 2.
Knob [1]
Effect Type [NoEffect, S.Comp…W.TalkMd]
Selects the effect type used by the insert
effect. For details on the available types,
refer to Effect guide in the included CD-
ROM.
Knob [2]
Dry/Wet [Dry, 99:1…1:99, Wet]
Sets the balance between the effect and dry
sounds.
Knob [3]
Effect parameter [IFx1Knob…]
This selects which parameter will be ed-
ited. The sub-display will show the name
of the selected parameter (e.g., “Sens“).
When you use “Effect parameter” (knob
[3]) to select a parameter, the display for
knob [4] will switch to the value of that pa-
rameter. The available parameters will de-
pend on the effect you choose for “Type.”
For details on the available effect types, re-
fer to the Effect Guide in the included CD-
ROM.
IFx1Knob, IFx2Knob: Use knob [4]
(“Value”) to select the effect parameter
you’ll control from knobs [1]–[4] in Play
mode. (☞p.80 SHIFT function “Knob as-
signment”)
Knob [4]
Value
This specifies the value of the parameter
you selected with “Effect parameter” (knob
[3]). The sub-display will show the value
directly (e.g., 0…127). The available param-
eters will depend on the effect you choose
for “Type.” For details, refer to the Effect
Guide in the included CD-ROM.
If “Effect parameter” (knob [3]) is set to
IFx1 Knob or IFx2 Knob, you can select the
effect parameters you'll control from knobs
[1]–[4] in Play mode. (☞p.80 SHIFT func-
tion “Knob assignment”)