Korg R3 - Carrier

55
34. CARRIER
In this page you can set the input level of the audio signal being used as the carrier
Knob [1]
Tmbr1Lvl (Timbre1 Level) [000...127]
Specifies the output level of Timbre1 (car-
rier).
If you are unable to hear the vocoder
effect, try adjusting the “Tmbr1Lvl”
parameter or the 38. Filt/Amp page
“Vcd Lvl” parameter (☞p.59).
Knob [2]
Input2Lv (Input2 Level) [000...127]
Specifies the output level of the signal
cannected to the [AUDIO INPUT2] jack.