⑤
When it skips to Confirm, short press (Power/OK) Button once
to conform and exit Licence submenu to return to Setup Menu.
Note: The license plate number needs to be edited or modified sequentially.
Audio record: Off, On (default)
Choose whether to record sound when recording videos.
Datestamp: Off, On (default)
Date and time will be stamped onto videos after turning it on.
G-Sensor: Off (default), Low, High, Middle
Set the sensitivity level of G-sensor to detect an impact to car.
While driving, if someone hits your car and the impact is detected by
G-sensor, then the camera will automatically lock the current video.
Note: Please choose a suitable sensitivity level for G-sensor according to
road conditions. The higher the sensitivity level, the more sensitive to
vibrations the camera is, and the more frequent the videos will be locked.
Since locked videos won't be deleted by Loop Record automatically, the TF
card may get full soon, then the device STOPS working for no storage space.
Parking Guard: Off (default), On Hardwire kit needed.
After set the sensitivity of G-sensor and the Timelapse is not turned OFF,
if someone hit your car while parking and detected by G-sensor, the
camera will turn itself ON to record a 30s video and locked video to
prevent being covered. The camera will turn itself OFF after recording.
Note: Hardwire ki needed. Since if you use a car charger, the built-in battery
has no enough power to support Parking Guard after your car is off.
Auto Power Off: Off (default), 1Min, 3Min, 5Min
If there’s no any operations on the camera in set duration, the camera
will auto shut down. Long press (Power/OK) Button to turn it on.
Screen Saver: Off (default), 1Min, 3Min, 5Min
If there’s no any manual operations on the camera in the set duration,
the screen will auto turn off. Short press any buttons to wake it up.
Frequency: 50HZ (default), 60HZ
Set the frequency according to the power supply specification in your
country/location. Normally, 60Hz for USA and 50 Hz for Europe.
To Next Page
Loading...
