③
Set the Loop Record to make camera record over and over by loop:
Setup Menu > Loop Record > 1min/3min/5min.
Situation 2: If above solution not work, please press "Reset" Button to
RESET camera. Still not work? CONTACT US: LESA_1688@163.com.
(10) TF Card is crooked /not going in slot easy?
Please make sure you align the TF card correctly. (See page 9)
(11) Memory card is inserted correctly in camera,
but it reminds: “SD Error” , “NO SD Card”, etc?
Situation 1: Please make sure you’re using the provided TF card or a
standard compliant memory card (See page ). If not, replace the card.
Situation 2: Have already used the provide TF card/a standard TF card?
Format SD and then restart the camera.
① Format the TF card first. ② Long press (Power/OK) Button to
turn the camera off; ③ Re-plug the power cable to camera and camera
restarts by itself, then check whether the problem has been solved.
Note: Please make backup for impartant footage in TF card first before
formatting. Otherwise, data in TF card will be deleted and cannot be restored.
Situation 3: If you still get the same issue after trying solution 1 and 2,
please check whether the TF card is defective.
How to check it? Let’s long press (Menu) Button to switch to Photo
Mode, then short press (Power/OK) Button to take snapshots. If a
shutter sound is heard, it means that the camera works well and the
inserted TF Card is defective. Please replace the TF card with a new
one. If not, please CONTACT US: LESA_1688@163.com.
(12) It reminds “Format SD Card”?
Please remember to format the inserted TF card first. If you are the
first use of camera or replace a TF card, you MUST format the TF card
via the camera. Or the card or camera won’t work normally.
(13) TF card has been formatted, but it still
always reminds to “Format SD Card”?
Please make sure you are formatted the inserted TF card with this
camera in Setup Menu rather than other devices. If you did format the
TF card in this device, please try the following solutions one by one.
To Next Page
Loading...