Kramer VIA Connect2 - For Installer: Connecting VIA Connect²; Connecting Device

Kramer Electronics Ltd.
VIA Connect² – For Installer: Connecting VIA Connect²
11
For Installer: Connecting VIA
Connect²
Always switch off the power to each device before connecting it to your
VIA Connect². After
connecting your
VIA Connect², connect its power and then switch on the power to each
device.
Connecting Device
If you wish to use a Kramer active optical pluggable HDMI cable with your VIA Connect²,
contact your local Kramer office to assist in purchasing the correct cable.
Figure 5: Connecting VIA Connect²
To connect VIA Connect² as illustrated in Figure 5:
1. Connect the keyboard and mouse.
2. Connect an HDMI display.
3. Connect to the LAN (default mode).
4. If required, connect a wired HDMI video source.
To enable participation in a presentation session (send and receive content), connect
VIA Connect²
and all participant devices (PCs/ MACs/ smartphones/tablets) to the same
network (LAN or WLAN).