Kramer Electronics Ltd.
VIA Connect² – For Web Administrator: Gateway Management Pages
3. Select the Auto Connect to Wi-Fi checkbox, to configure VIA Pad to automatically
connect to the meeting space Wi-Fi network.
Figure 23: VIA Pad Auto Connect Setting Page
Figure 24: VIA Pad Auto Connect Setting Page
The Auto Connect settings appear.
4. Define the following for the meeting space Wi-Fi network:
a. SSID – Name of the network
Make sure that you write it EXACTLY as defined. This parameter is case sensitive.
b. Authentication Mode – Security used by your Wi-Fi access point. Select from the pre-
set options: WEP Open, WEP Shared, WPA Personal, WPA2 Personal.
c. Encryption – Type of encryption key used by your router.
d. Key – Password required to join your network (up to 50 characters max).
VIA Pad settings are configured.
After clicking Apply Settings, the configuration is saved, reboot is not required.
Pairing a VIA Pad Device
Each VIA Pad device must be paired to your VIA Connect² unit before being used by a
meeting participant. To pair a VIA Pad device to your VIA Connect² unit, follow the
directions as shown in the image below. To run VIA Pad, refer to (see
Presenting from a
VIA Pad on page 101).
To Next Page
Loading...
