Kramer Electronics Ltd.
VIA Connect² – For Web Administrator: Gateway Management Pages
These options are enabled only
when Moderator Mode is enabled(see Moderator
on page 52).
Moderator – User can moderate and has access to moderator features.
Participant – User can join a meeting as a participant but cannot moderate.
6. Click Save.
A new user is added, and the User List tab appears with the new user added to the list.
Managing Network Settings
VIA Connect² enables you to do the following:
• Changing Device IP Address on page 18
.
• Connecting VIA Connect² to a Wi-Fi Network on page 19.
• Wi-Fi with AP Mode on page 20.
• Connecting VIA Connect² to an 802.1X Network on page 26.
Changing Device IP Address
By default, the IP address of your
VIA Connect² is set automatically by DHCP.
See below if you want to set a static IP address.
When changing these settings, please contact your IT administrator. Incorrect values can
cause a loss of communication.
To change the IP address of your VIA Connect² unit:
1. Click Device Management > Network Settings.
The LAN setting tab in the Network Settings page opens.
2. Under Connection Type, select Static.
3. Under Network Information, rename the Gateway IP.
4. Click Apply. The IP address of your VIA Connect² unit is changed.
Figure 12: LAN Setting Page
To Next Page
Loading...
