Kramer Electronics Ltd.
VIA Connect² – For Web Administrator: Gateway Management Pages
Site Management
VSM (VIA Site Management) is an optional, web-based software application (purchased
separately) that enables an administrator to monitor and make changes to all VIA gateways
connected to a network. VIA Connect² enables you to activate VSM management for a VIA
gateway and define which gateway functions are managed by VSM.
Contact your regional sales representative for more details about this solution.
If VIA discovery is enabled and configured in VSM, your VIA device is automatically
added under VSM supervision.
To configure VIA Connect² to be managed by VSM when VIA discovery is not activated:
1. Click Device Management > Site Management on the navigation pane.
The VIA Site Management page appears.
Figure 25: VIA Site Management Page
2. In the Step 1: Server Settings section, enter the VSM Server IP and the Gateway ID that
was defined in VSM for this gateway. User must have VSM access.
3. Click Validate and Save.
Changes take effect immediately.
must be able to connect to VSM while validating is in progress.
-OR-
Click Save for changes to be saved with no validation from VSM.
Since validation is not made immediately, any error entered at this stage, like
duplication of ID, must be corrected manually at a later stage.
4. In the Step 2: Configuration section, under the VSM column, select all the functions that
you want to be managed by VSM.
After clicking Apply and Reset, changes take 30 minutes to 1 hour to take effect, to
allow time to communicate with VSM.
To Next Page
Loading...
