Kramer Electronics Ltd.
VIA Connect² – For Web Administrator: Gateway Management Pages
Display Controller
VIA Connect² enables you to control a display screen that is connected to the same network
as your VIA Connect².
This feature enables you to configure one of the following actions:
• When the first person joins the meeting, the main display powers ON and when the last
person logs out of the meeting, the main display switches to other input source.
• VIA sends a command to toggle between the VIA input and any other device connected
to the same display.
To configure your VIA Connect² as a display controller:
1. Connect the display to be controlled to the same network as your VIA Connect².
2. Click Device Management > Display Controller on the navigation panel.
The Display Controller page appears.
Figure 69: Display Controller Page
3. Click the Activate Control switch.
4. Enter the Display IP address and Display Control Port of the display screen to be
controlled.
5. For Command 1, enter the command to send when someone first joins a meeting on
VIA.
6. For Command 2, enter the command you want VIA to send when the last participant
logs out of the meeting from VIA.
7. Select ASCII or HEX to define command format accepted by your display.
Refer to the User Manual for your display for the correct format of the commands.
Configuration of your VIA Connect² as a display controller will be done.
To Next Page
Loading...
