Kramer Electronics Ltd.
VIA Connect² – For Web Administrator: Gateway Management Pages
• Auto Disconnection – The VIA device can automatically disconnect participants whose
RSSI (Received Signal Strength Indicator) is weak or cannot be measured, indicating
that they are too far from the device to be in the meeting room. (Default = OFF)
Deviation – The change in signal strength that will lead to disconnection.
Attempts – The number of reconnect attempts before disconnecting.
It is advisable that you measure the RSSI strength and enter your own settings.
Figure 56: Settings Template > Presentation > Auto Disconnection
Power
Configure the following energy-saving automatic power settings in the VIA settings template
- Configuring VIA Settings Template on page 44
:
Figure 57: VIA Power Setting Tab
• Auto Power Off Timing – Set a time for VIA Connect² to shut down each day (default =
OFF).
• Auto Reboot Timing – Set a time for VIA Connect² to reboot each day (default = OFF).
Date/Time
Configure the following settings in the VIA
settings template (
Configuring VIA
Settings Template on page 44) that
define the date and time displayed on the
Gateway Dashboard Page:
Figure 58: Date/Time Setting Tab
Date and Time Format for Web Interface – Select the format for displaying the date
and time on the Dashboard page.
VIA Gateway Timezone Configuration – Select the time zone for VIA Connect².
To Next Page
Loading...
