Kramer VP-427X1

Kramer Electronics Ltd.
VP-427X1 – Using Embedded Web Pages
28
Configuring Network Settings
VP-427X1 enables you to use DHCP mode or to turn DHCP mode off and change Network
settings.
To configure Network settings:
1. Click Device Settings on the Navigation List.
The Device Settings page appears (see Figure 15).
2. Change Network settings as required:
a. In static mode (DHCP On is unchecked), change static Network settings as required:
 For example, change the IP address.
Figure 19: Changing the IP Address
 Click Set Changes. A confirmation message appears.
b. To select to work in DHCP mode instead of with static parameters, select the DHCP
On check box and click Set changes. A confirmation message appears.
3. Click OK to confirm the change.
The current web page session is disconnected. To access the web pages, reload with
the new setting.
Network settings are configured.