Kramer VP-427X1

Kramer Electronics Ltd.
VP-427X1 – Operating and Controlling VP-427X1
10
Using the OSD Menu
VP-427X1 enables controlling and defining the device parameters via the OSD, using the
front panel MENU buttons.
To enter and use the OSD menu buttons:
1. Press MENU.
2. Press:
▪ ENTER to accept changes and to change the menu settings.
▪ Arrow buttons to move through the OSD menu, which is displayed on the video
output.
▪ EXIT to exit the menu.
The default OSD timeout is set to 10 seconds.
Use the OSD menu to perform the following operations:
• Adjusting Image Parameters on page 11.
• Selecting an Input Signal on page 11.
• Setting Output Parameters on page 12.
• Setting Audio Parameters on page 12.
• Setting OSD Parameters on page 13.
• Managing EDID via OSD on page 13.
• Setting HDCP on page 14.
• Setting Sleep Mode on page 15.
• Setting Switching Mode on page 15.
• Defining FREEZE Button Operation Mode on page 16.
• Setting Ethernet Parameters on page 16.
• Defining CEC on page 17.
• Configuring TOGGLE Pin Behavior on page 17.
• Defining HDBT Range on page 17.
• Viewing Device Information on page 18.
• Performing a Reset on page 18.