Kramer VP-427X1

Kramer Electronics Ltd.
VP-427X1 – Operating and Controlling VP-427X1
15
Setting Sleep Mode
Auto Sync Off turns off the output after a period of not detecting a valid video signal on the
input(s) until a valid input is again detected or any keypad button is pressed.
VP-427X1 enables configuring the Auto Sync Off delay time when a connected display enters
sleep mode.
To set Auto Sync Off:
1. On the front panel press MENU. The menu appears.
2. Click Advanced and select Auto Sync Off.
3. Define Auto Sync Off according to the information in the following table:
Menu Item
Function
Off (default)
Leave outputs active always.
Fast
Disable outputs after ~ 10 seconds of no input detection.
Slow
Disable outputs after ~ 2 minutes of no input detection.
Immediate
Disable outputs immediately.
Sleep mode is defined.
Setting Switching Mode
VP-427X1 enables configuring for automatic switching of the input source upon signal loss or
when a source is plugged in.
To set the switching mode:
1. On the front panel press MENU. The menu appears.
2. Click Advanced and select Auto Switching.
3. Select the switching mode according to the information in the following table:
Menu Item
Function
Off
For manual switching.
Auto Scan
Scans for a valid input when no signal is found on the selected input.
Last Connected
Automatically switches to the last connected input and reverts to the
previously selected input after that input is lost.
Switching mode is defined.