Kramer VP-440 - Page 47

Kramer Electronics Ltd.
VP-440 – Protocol 3000
45
Command
Description
DISPLAY?
Get output HPD status.
FACTORY
Reset device to factory default configuration.
HDCP-MOD
Set HDCP mode.
HDCP-MOD?
Get HDCP mode.
HELP
Get command list or help for specific command.
IMAGE-PROP
Set the image size.
IMAGE-PROP?
Get the image size.
LOCK-FP
Lock the front panel.
LOCK-FP?
Get the front panel lock state.
MENU-CMD
Emulates menu navigation
MIC-GAIN
Set the microphone gain.
MIC-GAIN?
Get the microphone gain.
MIC-SELECT
Select the microphone.
MIC-TLK
Set mic talkover parameters.
MIC-TLK?
Get mic talkover parameters.
MIX
Set audio MIX.
MIX?
Get audio MIX.
MODEL?
Get device model.
MUTE
Set audio mute.
MUTE?
Get audio mute.
NET-DHCP
Set DHCP mode.
NET-DHCP?
Get DHCP mode.
NET-GATE
Set gateway IP.
NET-GATE?
Get gateway IP.
NET-IP
Set IP address.
NET-IP?
Get IP address.
NET-MAC?
Get MAC address.
NET-MASK
Set subnet mask.
NET-MASK?
Get subnet mask.
PROT-VER?
Get device protocol version.
RESET
Reset device.
ROUTE
Set layer routing.
ROUTE?
Get layer routing.
SCLR-AS
Set auto-sync features.
SCLR-AS?
Get auto-sync features.
SCLR-AUDIO-DELAY
Set the scaler audio delay.
SCLR-AUDIO-DELAY?
Get the scaler audio delay.
SCLR-PCAUTO
Set PC auto sync of scaler.
SN?
Get device serial number.
STANDBY
Set standby mode.
STANDBY?
Get standby mode status.
TLK
Set audio talkover mode status.
TLK?
Get audio talkover mode status.
VERSION?
Get firmware version number.
VFRZ
Set freeze on selected output.
VFRZ?
Get output freeze status.
VID-RES
Set output resolution.
VMUTE
Set enable/disable video on output.
VMUTE?
Get video on output status.