VP-773A - Technical Specifications
12.1 Default Communication Parameters
Example (Set display mode to Picture in Picture):
To reset the IP settings to the factory reset values, power cycle the device while holding in the
Ethernet Reset button, located on the rear panel of the unit
Full Factory Reset (including Ethernet reset)
Turn power off. Turn power on again while holding the RESET TO
XGA/720p front panel button. The LEDs blink. Full factory reset is
complete once the LEDs cease to blink and react normally.
Factory Reset through the Misc menu item
Factory reset via the Device Settings embedded Web page
Use “Factory” command or #Y 0,771,1<CR>
12.2 Input Resolutions
This section defines the input resolutions for each input
12.2.1 HDMI Input Resolutions
To Next Page
Loading...
