9.6 The Audio Settings Page
The audio settings page includes two tabs: the General tab (see Section 9.6.1) and
the Microphone tab (see Section 9.6.2). The features described in both tabs are
detailed in Section 6.3.
9.6.1 The General Tab
The General tab (see Figure 72) lets you set the general audio parameters for the
selected main window input and the outputs.
Figure 72: The Audio Settings Page – General Tab
Use the General tab to:
Set the DSP audio parameters
Select bypassing of the embedded audio input directly to the output
Choose whether the analog input takes over the embedded inputs
Select the power amplifier level from 1 to 4.
Note that if the Embedded pass-through is set to ON, Analog takeover, as well as
Mic 1, Mic 2 and Line mix, and the output volume are disabled.
To Next Page
Loading...
