Displays the selected input, input resolution and frequency, the output
resolution, firmware versions and IP Address M/P
If the selected output is the native output resolution, it will be displayed under "Native
Output" (the master connection will also appear, before “Native Output”) ; in case of an
explicit output resolution the title will be "Output:"
If the input video is encrypted, an HDCP icon appears next to the input information
Set:
Window Control – to Main Window Control to set the OSD menu to control
the Main window (letting you select the input and other parameters for the
main window) or to PiP Window Control to control the PiP window (letting
you select the input and other parameters for the PiP window) E
While browsing the OSD menu in the dual window mode, the window control
can be toggled instantly with a long press of the PIP button on the front panel
and a short press of the PIP button on the IR remote controller.
Note that you can select the window control only when in the dual window mode
H Position – to set the horizontal position of the OSD E
V Position – to set the vertical position of the OSD E
Transparency – to set the transparency to On or Off E
Transparency Gain – to set the transparency level (once set to transparent)
E
Transparency Bias – to set the transparency level E
Blink – to On for the selected item in the OSD to blink, or Off E
Blink Period – to determine the blinking rate E
Timeout – to 30 seconds before OSD timeout, 60 seconds before OSD
timeout or OFF (Off means that that the OSD appears continuously) E
Set:
V Keystone – to set the vertical keystone level E
Useful If the projector is located at an angle above or below the screen. In the OSD menu
the value range shows -80 to 80. For interlaced inputs, this feature is disabled
To Next Page
Loading...
