Image Shift Mode – to get the best image positioning possible. Set to Auto to
automatically get the best possible image positioning automatically; set to
Semi-auto to store the best image possible until the video resolution of the
selected input is changed (in which case the setting bounces to Auto); set to
Customize to keep the settings even if the video resolution of the selected
input is changed
Note that a video resolution change, when in the Customized mode, may
possibly result in an image positioning that is inaccurate with regards to the
new video resolution and may need to be set once again
Select the position and the size of the selected window: H Position, H Width,
V Position and V Height (see Section 6.2.1.2 and Section 6.2.1.1) M/P
The value range is dynamic. The FW prevents windows from exceeding the boundaries or
over-sizing. The position and size of the windows are saved to the system.
The size and position of the customized window (Main or PiP) remain valid even when
toggling the PIP button (front panel, remote control transmitter or protocol command).
The customized setup is cancelled only by explicitly selecting a preset Display Mode (see
first item in this table) or if a new customized setup is created.
Use the front panel + and – buttons, IR remote control transmitter or Web page to set the
position and height of the Main and/or PiP windows
The PiP window maximum horizontal active image area is 1600
pixels
The display mode setup, shown in Figure 11, is part of the entire system control
and the selected Single Window also shows the current aspect ratio (Best Fit):
Figure 11: Select the Display Mode
To Next Page
Loading...
